How To Transferring Files Directly to MakerBot Replicator Mini

MakerBot Replicator Smart Extruder
Engineered with improved components for better print performance. Experience a seamless workflow from start of a print to completion. Backed by an extensive Quality Assurance (QA) operation and technical support team to ensure your success. Based on our testing, it prints for over 700 hours; This number is the equivalent of the following: 7 large spools of MakerBot PLA filament 2,310 meters of filament 1.44 miles of filament.
Transferring Files Directly to MakerBot Replicator Mini

Fifth Generation MakerBot 3D Printers
You can transferring files directly to MakerBot Replicator Mini or the MakerBot Replicator Z18 by saving them to a USB flash drive and inserting the flash drive into the port next to the control panel on your 3D printer. Print files created for use with Fifth Generation MakerBot 3D printers should have a .makerbot file extension.

Transferring Files Directly to MakerBot Replicator Mini

If Connected via Wi-Fi
  1. Click the Print button to slice your model and send it to Replicator Mini. Click OK to exit the print dialog, or click Cancel Print to cancel the print.
  2. When the print file is sent to the MakerBot Replicator Mini, the Action Button will blink blue. Press the Action Button to confirm the print. The Action Button will then glow red, indicating it is heating the MakerBot Replicator Smart Extruder. When the Smart Extruder is fully heated, the MakerBot will start to print your model. For information wireless setup MakerBot Replicator Mini open this web
If Connected via USB Cable
  1. Click the Print button to slice your model. 
  2. To send the file to your Replicator Mini and exit the Print dialog, click Start Print.
  3. If you decide not to send the file, click Cancel Print.
  4. When the print file is sent, the Action Button will glow red, indicating that it is heating the MakerBot Replicator Smart Extruder. When the Smart Extruder is fully heated, the MakerBot Replicator Mini will start to print your model.
PRINT PREVIEW
In the Print dialog, click Print Preview to see:
  • Estimated print time
  • Estimated amount of filament your print will use
  • A rendering of what your print will look like
Files cannot be transferred directly to the MakerBot Replicator Mini Compact 3D Printer.

Earlier MakerBot 3D Printers

You can transfer print files directly to the original MakerBot Replicator Mini, the MakerBot Replicator 2 and the MakerBot Replicator 2X, as well as to MakerBot Thing-O-Matics equipped with a Gen4 Interface, by saving them to a FAT 16-formatted SD card with a 2GB or smaller capacity.  Save your print files to the SD card and insert it into the port on your MakerBot 3D Printer or Gen4 Interface. Print files created for use with earlier MakerBot 3D printers should have a .x3g file extension.

Files cannot be transferred directly to the MakerBot Cupcake CNC or to MakerBot Thing-O-Matics without a Gen4 Interface.

0 comments:

Post a Comment